Honeywell LCBS Training - February 22 - 23, 2011

Fundamentals of Pneumatic ontrol

This training is intended to provide the field service technician with the knowledge required to
service and maintain pneumatic control systems. Fundamentals of Pneumatic Control is a certified class,
Continuing Education Units (CEU’s) are available on request.

Course Topics
– Air station function, parts, set up and maintenance
– Pneumatic theory and control terminology
– Actuators, Thermostat calibration, Single and Dual Pressure Systems, Reverse vs. Direct Acting
– Relays, Positive Positioners, Transducers, Receiver Controllers

Register Today!

Register for Distech Controls Training - April 11 to April 15, 2011

Course #6001 EC-gfxProgram Graphical Programming software

This training is designed for the participants to gain the level of technical expertise necessary
to effectively and efficiently design, engineer, and program Distech Controls using Distech
Controls graphical programming language software.

Course Topics
– Commissioning, plug-in setup & registration, network variables
– Function block programming: I/O, comparator, logic, and math blocks.
– Device profiles: constants, variables, nvi and nvo blocks, HVAC blocks.
– Scheduler plug-in & wizard

Register Today!

Past Seminars

Below is a list of seminars that we have hosted on leading trends and technologies in the
commercial HVAC industry.

Contact us today if there is a class listed below that you would like CTC to host in the future.

• - Honeywell Introduction to LCBS Training
  
  
• - Honeywell Level II LCBS Training
  
  
• - AX Certification
  
  
• - CARE Level II
  
  
• - Circon Training
  
  
• - CSDS Seminar
  
  
• - iLon Connectivity
  
  
• - OPINS Seminar
  
  
• - Tridium Niagara TCP
  
  
• - Tridium AX Certification Training


• - VFD Training
  
  
• - Duct Smoke Detector Technical Training
  
  
• - Pneumatic Fundamentals
  
  
• - Spyder and WEBs Level II
  
  
• - System Sensor Contractor Training